Element Bushido: Front Inner Fenders

The fenders are designed for the stock Bushido configuration (SHORT BATERY TRAY) They can be used with the other Enduro body’s but may require some trimming on the overall width depending on the body. The inner fenders will be printed in Black.

Hardware needed: 2-m3x8, 4-m3x6

To install: Remove the shocks from the shock tower, Remove the shock tower from the chassis and the forward most bumper mounting screw, lengthen your pan hard link by 1.2mm by un screwing a rod end 1 full turn, the shock tower inserts into the fender and is attached again with the three screws you removed, attach the slider joiner with the m3x6 to the slider, attach the slider joiner to the fender with the m3x8.

IMPORTANT: Do not use power drivers on 3D printed parts. Over tightening printed parts and cause premature cracking and crushing. Always ensure you hardware will not bottom out in the screw pocket. This can also cause at 3D printed part to break prematurely.

Printed Parts - These parts will be printed in Black (Unless otherwise requested) using advances slicing methods for maximum strength. All 3D printed parts come with a lifetime replacement guarantee. If you break a part, simply send us a photo and your order number. The photo is simply to evaluate for common issues and help identify potential improvements to existing designs.

Contact us @ Sales@spare-timehobbies.com or PM us @ Spare-Time Hobbies on Face Book.